Retro TV Photo Frame & Tissue Box V4 (6-inch photo version)

Retro TV Photo Frame & Tissue Box V4 (6-inch Photo Version)

2026/06/14 Update

Friends have provided many constructive suggestions for this series of models, and the models have now been optimized based on their feedback

1. The inside of the photo frame has been widened by 1mm on each side

2. The top antenna is now magnetic. For installation: an additional 15mm diameter iron sheet and one 6mm diameter * 2mm thick magnet are required. Installation as shown:

------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

Key upgrades for this version:

1. Compared to V3, the photo size has been primarily adjusted, with a 6-inch version added based on the V3's exterior design;

2. The tissue dispensing direction has been changed to upward, which is more aligned with user habits;

3. An internal photo storage space has been added at the bottom, so you can place extra photos inside the box and change them at any time;

4. The frame has been optimized to a curved structure, creating a cuter shape;

5. The model is pre-configured for 4 corresponding parts designed for 6mm diameter * 2mm thick magnets by default, which can be changed after downloading and modifying as needed;

6. After the size reduction, it supports printing on all machine types, offering wider compatibility.

Note: The biggest difference in installation method is that the decorative panel and base plate are now purely glued together instead of using the original 4 rivets, because the rivets were difficult to install and could leave gaps on the sides;

I believe desktop ornaments should not only serve decorative purposes, therefore, this work is both a photo frame and a tissue box!!!

Don't be put off by the complex, multi-colored TV surface, because this is a stacked color design, with only one color per layer, so it is essentially single-color printing, and it also reduces the hassle of multi-part printing.

The method for placing photos in this work is very simple; I have reserved holes at the top.

Inside, there is a tissue box with enough space for most tissue sizes. The photo frame and body are connected by 4 magnetic attachments that are 6mm wide * 2mm thick, making it very convenient to change tissues.

The specific assembly method is shown in the figure below:

Finally, I hope everyone likes my work!!!