Hydrogen Bomb Pull Copter Launcher
Print Profile(1)
Description
Boost Me (for free)
If you like my work, please boost me, thank you!!!
Instructions
1. For playing as a pull copter, only printed parts are needed, no additional parts.
2. For playing as a spinner, a φ3X16mm iron pin is needed. The iron pin is installed in the center of the red top cover, with about 1mm of its outer end exposed. Additionally, a magnet with a diameter of 5mm and a thickness of 3-4mm is required, to be installed inside the drive shaft near the red top cover. You can pause the print to insert the magnet.
3. If it doesn't spin after installation, there are usually two reasons: first, incorrect planetary gear alignment; second, the sun gear and drive shaft are not fully seated axially, causing the entire drive gear shaft to seize.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)