Pro Magnetic Labels for SKROAM and PRAKI

Filament Label Pro for SKROAM and PRAKI Containers

Keep your filament storage clean, organized, and even more useful with Filament Label Pro — a magnetic filament label holder designed for SKROAM and PRAKI filament containers.
 

This Pro version adds a large 52 × 39 mm label area and integrated layer light test fields, so you can not only label your filament clearly, but also check how much light passes through the printed material at different layer thicknesses.

No glue. No clips. No mess.

>>> SKROAM AND PRAKI Label Collection <<<

🔧 Compatibility

Designed for SKROAM and PRAKI cereal-style filament containers.

The labels may also work with other smooth plastic containers. Depending on the surface and shape of the container, the hold or alignment may vary.

✅ Features

Large 52 × 39 mm label area – ideal for printed filament labels or written information
Two versions included – one with a flat sticker guide and one with a smooth front surface
Integrated light test fields – compare filament transparency at 1–4 printed layers
Magnetic & reusable – swap labels within seconds without leaving residue
No glue, no clips – simple installation without permanently modifying the container
Clean and readable design – ideal for organized filament shelves and maker setups
Press-fit magnets – no glue required, depending on your printer tolerances and magnet dimensions

🏷️ Label Information

The label area is designed for printed labels in a 4:3 ratio.

Recommended label size:

52 × 39 mm
4:3 ratio
Approx. 196 × 147 px at 96 DPI

Labels can be created with the Bambu Label Generator and then scaled to the correct size:

https://bambu-labelgen.socuul.dev/

💡 Layer Light Test

Filament Label Pro includes four light test fields with different remaining material thicknesses.

When printed with 0.2 mm layer height, the fields represent:

0.2 mm = 1 layer
0.4 mm = 2 layers
0.6 mm = 3 layers
0.8 mm = 4 layers

Hold the label against a light source to see how much light passes through the filament. This works best with transparent, translucent, white or light-colored filament.

🧲 Magnets

Designed for 4 × 2 mm round magnets.

Each label holder requires 4 magnets.

The magnets are designed as a press fit. Fit may vary slightly depending on your printer, filament, and tolerances.

Please pay attention to the correct magnet orientation when inserting them.

🖨️ Recommended Print Settings

Layer height: 0.2 mm
Adaptive / variable layer height: off
Supports: no
Print orientation: front side on the build plate

The light test fields are designed for 0.2 mm layer height. Using a different layer height may change the result of the light test.

Press-Fit Silica Insert for SKROAM / PRAKI Filament Containers