H Series Plate Labels H2C H2S H2D
Print Profile(1)
Description
Here you can find the print for smaller printers (P2S, X2D, X1C etc.):
Have you also had problems with print bed adhesion?
Often it is because you print PLA and PETG on the same plate. These materials repel each other.
Therefore, you should use one side only for PLA and the other side only for PETG.
You can label which side is for which filament with my holder.
The labels should fit all Bambu Lab H-series plates. So H2D, H2C, and H2S
The holders are designed to accommodate a round magnet up to 9mm x 1mm. This magnet then holds the two halves together on the print bed. However, if you only have weak magnets or none at all, you can simply join the halves with a drop of glue.
The magnet must not be thicker than 1mm, but its diameter must of course be smaller.
Please pay attention to the alignment of the two halves! The side with the small step goes upwards. So towards the center of the print plate. See the pictures for this.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)