Search models, users, collections, and posts
BattleTech Aces Deck Holder Case
Remixed by
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
6.2 h
2 plates
Open in Bambu Studio
Boost
2
1
0
0
1
0
Released
Description
I remixed/rehashed/kitbashed this Daggerheart box and some BattleTech storage boxes into a box to store my Alpha Strike Aces cards along with these holders:
https://makerworld.com/en/models/2625551-battletech-aces-deck-card-holder
The logos/graphics were swiped from this:
https://makerworld.com/en/models/1104077-battletech-card-case
You can get away with 0.2mm layer heights, it's completely fine and it cuts the print time in half.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)