BetaFPV air65 - Canopy for Caddxfpv Ant camera

Canopy for BetaFPV Air65 modified to mount a CaddxFPV Ant Nano camera. 

Designed for side‑mount installation using the two factory screw holes on the Ant Nano. No cutting, drilling, or frame modifications are required — the only requirement is having the correct camera cable for your AIO.

The canopy is optimized for TPU printing only (rigidity of PLA/PETG will cause poor fit and WILL crack). 

Typical print weight: ~1.63 g (varies slightly depending on filament density and slicer settings).

Camera angle:

• Tested flying indoors at 0°
• Should install correctly up to the default 25° angle or slightly higher

This design keeps the Air65 lightweight, durable, and fully compatible with the stock frame and hardware.

UPDATE 26/06/2026 - after numerous collisions I found that its a bit harder to convince camera to stay leveled with frame when compared to stock camera. Adding a second model with 4th leg. A bit of extra weight (~0.15g) but now holds level much better.