NEEWER RGB61 Honeycomb Grid

Compact Honeycomb Grid for the NEEWER RGB61

This honeycomb grid was specifically designed for the NEEWER RGB61 to direct light more precisely and reduce side spill. Especially for RGB effects, product photos, video recordings, or small lighting setups, the honeycomb grid ensures a more controlled light beam and a cleaner look.

The grid simply attaches to the front of the RGB61. No screws, magnets, or additional parts are needed. The fit was prototypically tested and successfully printed in PLA.

The model is optimized for a good balance of stability, short print time, and low material consumption. The honeycomb structure is firmly connected to the frame and has been adapted to be cleanly printable without support.

Features:

• Compatible with NEEWER RGB61
• Honeycomb grid for reducing light spill
• Simple push-on fit
• No additional screws or magnets needed
• Optimized for PLA
• Sturdy, but material-efficient design
• Printable without support
• Good addition for photo, video, and streaming setups

Print Recommendation:

• Material: PETG or ASA
• Layer height: 0.20 mm
• Walls: 2–3
• Infill: 10–15 %
• Support: No
• Scaling: 100 %
• Orientation: Honeycomb side flat on the print bed

Note:
This is not an official NEEWER product, but a self-designed 3D-printed accessory for the NEEWER RGB61.

The model is provided as is.

I cannot offer individual support, troubleshooting, or special adaptations for different printers, slicer settings, materials, or dimensional tolerances of the RALENO PLV-S116.

Please check the dimensions before printing and use the model at your own risk.