Search models, users, collections, and posts
4mm PTFE Tube Stopper Plug for PolyMaker PolyDryer
Remixed by
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 0% infill
Designer
23 min
1 plate
Open in Bambu Studio
Boost
1
2
0
0
0
0
Released
Description
This Model is an improved remix of this stopper by Muse. Additionally, it incorporates an idea by @user_858754080 to add a slot that can retain the end of the filament.
It is intended for use with 4 mm PTFE tubes. PETG, ABS, or any other temperature-stable material is recommended.
Please note: Due to the filament channel that is integrated into this stopper, the rubber plug will not fully seal the container when no filament is protruding from it. I therefore recommend using this stopper on only one of the two filament access ports.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)