Search models, users, collections, and posts
Duck Head Toothbrush Cover for Oral-B
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
1.1 h
2 plates
Open in Bambu Studio
Boost
0
6
0
0
2
2
Released
Description
Protect your bristles and give your Oral-B electric toothbrush a little personality while it waits for you to brush your teeth with this cute cover for the brush head.
Assembly:
- Eyes: the holes are designed with just enough clearance for black 1.75mm filament. Use needle nose pliers to push the filament in as far as it will go (around 2mm), then snip it off flush with the face. Note: It's easier to insert the eyes before the bill is put into place. (Use white filament if head is printed with black filament.)
- Bill: use a drop of super glue to hold the bill in place
Printing: Recommended to print the parts in the orientation provided, with lightweight tree support (build plate only) for the head. PLA or PETG are fine, 0.2mm or smaller layer height.
Pairs nicely (as shown in photos) with Misael's Oral-B Duck Feet. https://www.printables.com/model/183971-duck-feet-for-your-oral-b-toothbrush
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)