Search models, users, collections, and posts
CR-6 se Push-in V-slot Covers (minimalist)
Remixed by
IP Report
Print Profile(0)
Add the first print profile to earn points
Boost
1
1
0
0
1
0
Released
Description
These are custom sized to fit the CR-6 SE Printer.
There aren't nearly as many places to put these covers on the CR-6 se as there is for the Ender 3, but at least it's something.
I titled the files by where they should go, so it should be pretty self-explanatory.
*If you want the front and rear of the middle section to be covered, print the middle set twice.
*If your spool holder is clipped on the rear side, print the middle set three times, as one set can just go to front left. **You'll only need one of the rear pieces if your spool holder is clipped back there (BackSingle).
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)