Search models, users, collections, and posts
2 door Jeep Back Seat holder
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.4 h
1 plate
Open in Bambu Studio
Boost
4
2
0
0
0
1
Released
Description
Often I keep the back seat of my 2 door jeep wrangler JL in the upright position to give me more room for groceries. This is a simple plug that fits in the locking park of the legs and I use a 12" bungie cable attached to a D ring on the jeep and the end of the plug to jeep the seat from bouncing up and down as I drive.
I've printed it in both PLA and Petg, but I would recommend Petg for the heat resistance.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)