Search models, users, collections, and posts
RepRack End Clamp
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
57 min
1 plate
Open in Bambu Studio
Boost
41
110
12
6
201
98
Released
Description
I designed this to ensure that my EMT was aligned correctly on both ends and to keep me from sticking my fingers into the sharp hole.
Note: The picture is from an earlier version where the screw holes were blocked on the outside face also. My screws were just short enough that this was fine but yours might not be so I added the holes back.
Warning: If you print a third party profile you may not be getting the latest version or the highest quality print.
If you like this project, please don't forget to ❤ Like, ★ Rate, and 🚀 Boost!
Boost Me (for free)
If you find this model useful please consider sending a boost my way as it really encourages me to keep designing.
* Some of the links above may be affiliate links
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (12)