Search models, users, collections, and posts
Supports calibration test
IP Report
Print Profile(1)
Default with supports, 0.2mm layer, 2 walls, 15% infill
13 min
1 plate
Open in Bambu Studio
Boost
23
67
22
2
298
214
Released
Description
small (20mm x 20mm x 10mm) supports test
features:
- short print time (20 minutes on 0.2 quality mk3s+ profile)
- horizontal and vertical m3 hole
- convex and concave vertical fillets
- convex and concave horizontal fillets
- large overhang close to the build plate
- bottom of a sphere printed on top of supports
- supports beginning on the print itself (on both flat and round surfaces)
- thin, rounded overhang
files are already in the correct orientation
print using supports: everywhere
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (22)