Search models, users, collections, and posts
Skadis - Deburring Tool Holder
IP Report
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
53 min
1 plate
just the holder, no clips
Designer
48 min
1 plate
6 pack - tclips
Designer
21 min
1 plate
Open in Bambu Studio
Boost
111
280
54
3
398
218
Released
Description
deburing tool holder.stl
- secured to the pegboard with 2 x Tclips
- Fits a standard plastic deburring tool like the one pictured
- Tried to make it use space efficiently, but this design requires the are above the top of the tool to be clear from obstructions, so do keep that in mind
tclip_adjusted.stl
- slightly tighter fit than the original “T-Clip for Unpainted Skadis.stl” by Will
- original tclips should work too but i have not tested with it
- these clips fit very tightly, negating all wobbles but might be affected by printer tolerances
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (54)