Sidewinder Extruder Cover (various, backlighting possible)

I have a small selection of extruder sleeves for you. These have air slots for better heat dissipation. The Origianl housing becomes very warm (>50°C) during long prints. Here there is more space inside to the top and when moving the warm air can be dissipated. The engine is no longer so warm and thus spared.

With the X2 the original BL-Touch fits under the housing.

There are covers with:

Logo and filigree lettering (Extruder-Artillery_small.stl)

Logo with big lettering (Extruder-Artillery_big.stl)

Logo (Extruder-Artillery_logo.only.stl)

additionally needed

Flat cable protector (Flat.Cable.Protector.stl)

2-3 x M3 16mm (2 are enough at the flat cable connector)

You can use any filament, as the case is far enough away from all heat sources. I used ice-white PLA+.
The logo should be on the print bed. You might use support for it. I didn't need it. A backlight can be installed.

Feel free to leave a comment if you have a question.

I am happy about a like / make!

Keep it simple!