Search models, users, collections, and posts
Creality Ender 3 V3 KE / SE - Blocks for Inserts
IP Report
Print Profile(2)
0.2mm layer, 6 walls, 35% infill
1.7 h
1 plate
0.2mm layer, 2 walls, 15% infill
1.1 h
1 plate
Open in Bambu Studio
Boost
219
293
41
8
1.2 k
57
Released
Description
***DO NOT USE ANY OTHER PRINT PROFILES - THEY ARE NOT CORRECT**
Use these blocks to reinforce the base of the printer and also to position for accurate drilling of holes for making the printer more MOD-able
SPECIAL NOTE** It is a good idea to-pre-drill the blocks with a 4mm bit to clear the holes before gluing them into place. This makes it much less likely to tear the block off if the adhesive has not completely set.
To do this upgrade, I highly recommend you watch the video.
Printed from ABS
0.4N
6W/T/B
35% Cubic/Gyroid
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (41)