Gravity_hook/重力抓钩 kitcard_version & separate parts

Update: Updates separate frameless components for direct use.

A gravity hook has been made into a 3D printed version.
It can be used as a toy or to hang items that don't weigh too much.

The specific load capacity has not been tested.

Recommended to use PETG material for printing.

The pin can be replaced with metal material, but be careful to adjust the tightness, the proper tightness can ensure the success rate of gravity clamping.

If metal screws are used, the nut part should be glued.

Printed pins are easily broken and a separate file will be uploaded at a later date for easy replacement.

The holes in the panels that are combined to form the cross hooks are intentionally made smaller to allow for a tighter fixation.

The clips in the cross-hooked condition are easily broken and will be replaced in a separate document to be uploaded at a later date.
A simpler method is to use an elastic material, such as a rubber band, to bind it directly.