Search models, users, collections, and posts
Bar Keepers Friend Lid
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill (Snug Fit)
16 min
1 plate
0.2mm layer, 2 walls, 15% infill (Loose Fit)
16 min
1 plate
Open in Bambu Studio
Boost
171
781
91
23
1.1 k
1 k
Released
Description
Lid to keep a can of Bar Keepers Friend from getting too much moisture in it. The inner lip provides a better hold and helps seal out moisture, but is easy to remove. I like it printed in a flexible material, but works great with anything.
Tolerances are quite narrow at this size. If the fit is too loose or too tight, adjust the x and y scaling in your slicer by very small increments.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (91)