Reeno

cover

20240305_154018_b1b74d59-8389-4ae8-8204-849e33faf39f.jpg

20240305_154043_76e97b18-be99-4eda-9c34-8c8d9aac3cdb.jpg

Cable Route 1_50d65711-3179-4229-95f8-b31cd7e7010c.png

Cable Route 2_510604a3-065f-4918-a2f0-5a86b2aa697b.png

Cable Router 3_2dd02e0f-78ac-4da7-9f6d-9434298cc663.png

CAble Router 4_ccf01f8d-20df-4e9b-b703-a98d51da01d5.png

COVER 1_4f1e5aba-149a-4439-986d-ea85bcd45273.png

COVER 2_5a00ebad-e604-431a-86d3-b25610b0e95f.png

x1 40mm

plate_1.png

x2 40mm

plate_2.png

x3 40mm

plate_3.png

x4 40mm

plate_4.png

x8 40mm

plate_5.png

x1 80mm

plate_6.png

x2 80mm

plate_7.png

x3 80mm

plate_8.png

x4 80mm

plate_9.png

Whistler

472363313_951490143743310_6433177367569432957_n.jpg

473610828_1414158412892165_2575305798063803042_n.jpg

Skärmbild 2025-01-18 121841.png

There was no print profile for this model.It fit the spot for just what I needed, so I made the profile and added it.All credit should go to <a target="_blank" href="https://makerworld.com/en/@Reeno" rel="nofollow noopener">Reeno</a> for making the model.&nbsp;I added each version to its own plate, adjusted for the A1 Mini.I also added a version where I cut the screw tab off on one side for mounting the router on floor or door mouldings.The cut version can also be printed twice for when you need to double the amount of cables, such as getting x8 cables by using two x4 routers fit side by side. For my print photos I tried a variant with cutting all routers thinner by the bottom, this shaved 35 minutes off the printing time for the pictured plate and they work just as well. A notice! This model does not work with Cat6 ethernet cable, they are too thick. You can trim off the top entry point of the routers to get them in, but it takes some time and finess. I will work on scaling the model properly for Cat6 shortly.

0.2mm layer, 3 walls, 15% infill

474232757_2037683443416472_8901354715353426335_n.jpg

20% larger version for thicker Cat6 ethernet cable.Maker sure to slide the cable in from the opening, if your cable is already terminated, go at an angle, it will fit nicely if you just make sure the cable is sliding. Do not push the cable straight down, it may hurt your cable.

120% for Cat6 cable - 0.2mm layer, 2 walls, 15% infill

Couldn&#39;t find a cable router that I liked, so I made my own! &nbsp;These work great to router standard ethernet cables and they&#39;re perfectly snug.&nbsp;Other lengths and sizes available, just ask!

Ethernet Cable Router

ASIA

Print Profile(2)

Description

Comment & Rating (32)

License

Related Models