MTG Counters + Case - Fits in Deckbox

If you like this model and it's not too much trouble, please hit the 👍 button - it helps out a lot 😀

This is a remix off of ChappIO's really nice MTG Counters design. The following changes were made:

• Made the box 1mm overall thinner (only 4.2 mm thick!)
• Uses squared counters rather than the winged counters
• The counters use MTG Arena icons
• The counters are 1mm thinner for an overall thickness of only 1mm
• Added text and logos to the lid

All parts were printed using a 0.4mm nozzle (standard sized nozzle) to make this as accessible as possible to everyone! 

Please note, I have only tested a flat build plate (not textured)

These counter boxes fit inside of most deck boxes. I tested all the deck boxes I own and they fit inside each one without issue. The overall box itself is the same size as my Ultra Pro eclipse sleeves in terms of length and width! The box lid may be a bit tight after printing. Sliding it back and forth a few times should loosen it up. It does stay closed when shaking it, so you shouldn't have any issues with the lid coming undone.

The box lids and counters only require a single color swap to save on waste! The attached print profiles are all set and ready to print. All you need to do is pick and choose which counters you want to print by copy/pasting on to a new build plate and sending it off to print! The following counters are available:

Ability/Boardstate Counters:

+1 / +1 Counters:

-1 / -1 Counters:

Tokens:

Be sure to check out my MTG 3D Print Projects page if you are interested in even more MTG prints like this from myself and other very talented makers!