Search models, users, collections, and posts
Mounts for Jeep Ducks
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.4 h
4 plates
Open in Bambu Studio
Boost
209
452
21
14
372
217
Released
Description
Still new to 3D modeling but tried my best to make a display mount for my ducks. Keeps them from sliding around. There is a model for 1, 2, 3 or 4 ducks.
I recommend printing in PETG since they will probably see the extremes of heat/cold depending on where you live. I added slits inspired by the iconic Jeep grill so they wont block the defroster. Fits most ducks but if the hole on the bottom is small you might have cut it open a bit to fit.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (21)