Search models, users, collections, and posts
Poop Chute Right Side w/ Magnets with bucket
Remixed by
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 10% infill
Designer
6.3 h
3 plates
PETG Translucent 0.6mm nozzle, 0.28mm layer
16.2 h
4 plates
Open in Bambu Studio
Boost
70
214
78
38
567
395
Released
Description
Based on the setup of my printer, regular poop chutes weren't going to work for my P1S so I set out to find one that goes to the right side. I found this one https://makerworld.com/en/models/172519 but it was held on by a screw I did not have. I remixed it to use 6x3 magnets down the side of it to hold it on by magnets. This is what we have here. This model will take five 6x3 magnets but I can reconfigure it if you ask for other sized magnets.
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (78)