Search models, users, collections, and posts
Minibike stand rear axle
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
7.2 h
1 plate
Open in Bambu Studio
Boost
6
11
0
0
11
3
Released
Description
A stand for a Minibike,
The rear axle on mine has steps for your feet, there you can lock the bike in so it won't fall,
meant for showing or storing.
you only need 1 short m5 bolt, nut and I would recommend 2 washers
for the locking system 2 longer bolts, 2 nuts, and also recommended 2 washers.
The system is meant for a minibike with the steps 14cm above the ground,
I changed the way of printing after mine was printed so yours would be nicer around the arches and the connection at the bottom.
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (0)