Search models, users, collections, and posts
HSW Makita Battery Holder
Remixed by
IP Report
Print Profile(1)
No supports, 0.2mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
Open in Bambu Studio
Boost
45
106
14
10
124
84
Released
Description
HSW Makita Battery Holder
This model is a remix of Flobi's excellent makita battery holder. This design has been remixed to replace the multiboard mounts with ones suitable for the HSW system. Two mount points have been used just like the original to ensure the battery holder is nice and secure.
Print Settings:
This holders can be printed in either PLA or PETG. The part is printed on a angle and no support should be needed if you have good bed adhesion.
- Material: PLA/PETG
- Layer height: 0.2mm
- Perimeters/Wall Loops: 2
- Sparse Infill Density: 15% Gyroid
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (14)