LUFFY ONE PIECE HUE FORGE INSANE

FILE IS READY TO PRINT

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

PLA BambuLab Basic Black Transmission Distance: 0.6

PLA BambuLab Basic Red Transmission Distance: 4

PLA ERYONE MANGO Yellow Transmission Distance: 8

PLA BambuLab Basic Jade White Transmission Distance: 5

Swap Instructions:

Start with Black

At layer #7 (0.64mm) swap to Red

At layer #13 (1.12mm) swap to MANGO Yellow

At layer #16 (1.36mm) swap to Jade White for the rest.

Reminder:

My models mostly cover the entire bed,
this means the purge line is sometimes
running through the bottom of the print.
You have 3 options here:
- Leave as is, you can just cut them of afterwards.
- Remove immediately after the purge line is printed.
- Scale the model:

*** WARNING ***
WHEN SCALING THE MODEL, BE SURE TO NOT SCALE THE Z-HEIGHT!
The Z-height must always be as original, otherwise the print
is messed up.

If u want to support my work

https://www.paypal.com/paypalme/MarcoMaineri?locale.x=it_IT

For request send me dm