Search models, users, collections, and posts
Replacement Wheel for 22in Weber Kettle Grill
IP Report
Print Profile(1)
0.2mm layer, 4 walls, 15% infill
Designer
6.3 h
2 plates
Open in Bambu Studio
Boost
21
54
0
1
53
2
Released
Description
This wheel replaces the wheel from a 22inch Weber Kettle Grill. It probably will fit a lot of other grills as well. The wheel diameter is 6inches (150mm) and it will fit a 10mm shaft.
I purchased a 22inch Weber Kettle Grill from an Amazon returns website and it was missing a wheel. This wheel is a drop in replacement. I recommend printing it in PETG or ASA as to have a chance of surviving outside. I printed it in PETG as I had plenty on hand and it is much cheaper. I will report back as to how well it holds up. Additionally I would increase the number of walls, as well as the thickness of the top and bottom layers.
I would recommend tossing a couple of M10 washers or the optional spacer in between the grill and the wheel.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)