Search models, users, collections, and posts
Minimal Raspberry Pi 0 Case
IP Report
Print Profile(2)
With GPIO cover - 0.2mm layer, 2 walls, 10% infill
Designer
25 min
1 plate
Without GPIO cover - 0.2mm layer, 2 walls, 10% infill
Designer
23 min
1 plate
Open in Bambu Studio
Boost
21
72
12
1
152
96
Released
Description
A simple, low-profile/minimal case for a Raspberry Pi Zero/Zero 2 w.
There are two options: Without a GPIO cover, and with a GPIO cover.
Materials needed:
[4] m2.5x10 screws
Assembly instructions:
Simply thread the screws through the top, place it on the pi, and then screw it into the bottom half.
---------------------------------------------------
I hope you find this useful :)
Boost Me (for free)
If you like my work and would like to support me, please consider leaving a boost :)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (12)