Search models, users, collections, and posts
Filament Welder/Splicer holding plates all springs
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
17 min
1 plate
Open in Bambu Studio
Boost
43
125
15
2
199
74
Released
Description
Adaption to the original:
My main problem with the original was that my pdf tube was a little thicker than the original and the spring would not fit. So I changed the design so you can use any 2cm long spring in the holder and offers a quicker cooling of the spring.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (15)