Poop Box for X1C / P1P / P1S / P2S - Normal Mode

This is a poop bucket for the Bambulab X1/P1/P2 Series.

I designed it to be easy to print and use a low amount of filament.

It takes about 4.5 hours (at 0.20mm, standard speed) on a X1/P1/P2 printer, and uses 174g of filament.

This model should be printed in regular mode (not vase/spiral) with the following recommended settings:
- Layer height: 0.20mm 
- Wall Loops: 3
- Bottom/Top shell layers: 3
- No need for infill, supports or brim

In the back you can glue 4 magnets to make it stick to the printer. 
It has holes/spots with several diameters to fit any of the following magnet sizes (diameter x thickness):
- 5mm x 3mm
- 6mm x 3mm
- 8mm x 3mm
- 10mm x 3mm

Even the smallest magnets are able to keep it in place.

I also published this same model but for vase mode print (spiral), which allows a faster print with less filament. Check it at my profile models.