Search models, users, collections, and posts
Adjustable Doll Bed
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
11.8 h
3 plates
Open in Bambu Studio
Boost
10
29
0
0
10
4
Released
Description
An adjustable doll bed.
Just print connector, slat and feet and put it together. A 5th foot need to be placed in the middle of the bed to be more stable, you may need more depending on the size of the final bed !
/!\ The slat can be difficult to put into the connector, but after it doesn't move which guarantee solidity !
No support needed. Outer Brim for the slats.
Dimensions :
- slat : 1x10cm
- connector : 2x2x2cm
- The quantity of each piece in the 3mf match the bed in the picture which is 24x46x11cm
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)