Search models, users, collections, and posts
PowerA Wireless Controller for Switch Joystick
IP Report
Print Profile(1)
0.08mm layer, 2 walls, 75% infill
Designer
49 min
1 plate
Open in Bambu Studio
Boost
10
17
7
1
47
29
Released
Description
Joystick broke on my third-party PowerA Wireless Controller for Nintendo Switch, so I made a replacement joystick. The controller is super easy to take apart, and the joystick is a good fit. Works perfectly. The layer lines and texture from build plate should give sufficient grip, but I had a rubber cap on hand so I popped that on top for better feel.
Printed with 0.08 mm layer height, randomized seam and 75% fill for extra strength, but you can probably get away with much less.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (7)