Search models, users, collections, and posts
Vintage Volkswagen Service Logo Clock
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 20% infill
Designer
6.4 h
1 plate
Open in Bambu Studio
Boost
104
156
25
24
139
75
Released
Description
This clock is 230mm in diameter with a 9mm hole for the clock stem to fit through.
There is a square piece on the back side for the clock mechanism to fit in. I made this approximately 60mm x 60mm so that any clock mechanism should fit.
I printed this on a X1C and the print profile worked just fine for me, but you might find better settings to use on your printer.
Boost Me (for free)
I hope you enjoy this VW clock as much as I enjoyed making it!
I would greatly appreciate it if you could rate my model and profile, Thank you and enjoy!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (25)