Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
33 min
1 plate
Open in Bambu Studio
Boost
16
50
10
3
50
41
Released
Description
This is a little support frame for your hydroponics plants.
Easily fits over the standard sponge baskets. It also fits over my other design which is a reusable light cap for the sponge basket.
I had a little trouble with the model being knocked off the plate when it was printing near the top of the holes, so I added the brim and printed in Silent (slow) mode and it was perfect.
**** print on silent mode****
Internal diameter of the base is 45.8mm
31mm tall
I included a v2 frame as well. It is slightly taller and may need supports.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (10)