K+ FLYING WING FPV DRONE

In this project, the objective was to build a FPV flying wing with over 700mm wingspan that could be printed under 24 hours at 0.2mm layer height and is easily Assembled. The drone comprise of only 8 parts. You do not need a flight controller or anything else to run FPV on this model.

3D Printed Parts

-2 Elevons
-2 Wing Tips
-2 Wings
-1 Fuselage
-1 Canopy

Electronics
- 2 x Servos Motor 9g 
- A2212 Motor (1000kv or 2000kv)
- 1 x 30 Amps ESC
-Micro FPV Camera Kit (with transmitter and receiver)
-RC Transmitter/Receiver
-6045 Propeller

Tools
-3D Printer (With one Axis larger than 250mm)
-Hot glue Gun & Sticks 
-Cyanoacrylate glue
-RC elevon rods 

Checkout Build Video at: 

3D PRINTING SETTINGS

0.2mm layer height