Search models, users, collections, and posts
FastTrack Rail End Cap
IP Report
Print Profile(2)
0.1mm layer, 2 walls, 15% infill, PLA
Designer
45 min
1 plate
0.2mm layer, 2 walls, 15% infill, ASA
Designer
1.4 h
1 plate
Open in Bambu Studio
Boost
33
130
16
10
139
98
Released
Description
These are end caps for the RubberMaid FastTrack Rail system. They snap onto the ends of the FastTrack Rail. This helps to improve the look of the mount and to keep the plastic portion of the rail from sliding.
Parts Included in Print
The attached model includes the following parts:
- 1 End Cap for Left Side
- 1 End Cap for Right side
Printing Notes
- PLA Profile: The default 3mf profile posted is setup for printing in PLA.
- 0.10 layer height is used to improve print quality.
- Manual supports are required for the print orientation.
- ASA Profile: My personal application could see fairly high temperatures, and I was worried about how the PLA would hold up over time. In addition to the PLA print profile, I also attached an ASA print profile. This profile includes brim to help alleviate print lifting when printing ASA. Due to the difficulties printing with ASA, your print settings may require additional modifications.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (16)