Leifeng Wall-Mounted Charging Stand

Having previous experience in non-standard automation, I have a preference for 3D design. So, I immediately installed SW and started my own journey of modification.

The reason for this project was that I previously had an electric toothbrush holder, but it could not meet the charging requirements. I don't like it when my toothbrush runs out of power, and I want it to always be in its best condition.

Therefore, I dismantled the old holder, took a look at the connecting structure, and started the design of the first version.

However, due to some errors, the dimensions were incorrect. So, I redesigned the second version and added drainage holes.

I hope to get some thoughts and suggestions from everyone as I embark on my DIY journey!