Search models, users, collections, and posts
HSW Socket Set Holder 1/4 and 3/8 inch Drive
IP Report
GIF
Print Profile(2)
0.2mm layer, 2 walls, 20% infill
Designer
2.3 h
3 plates
A1 Mini - 0.2mm layer, 2 walls, 20% infill
Designer
2.6 h
3 plates
Open in Bambu Studio
Boost
124
375
31
11
452
305
Released
Description
HSW Socket Set Holder 1/4 and 3/8 inch Drive
This Socket Set holder is designed to fit ¼ and 3/8 drive sockets. The holder is designed so both tpyes of sockets can be mounted by mix and matching the socket adapters. The socket adapters simply slide in from the end of the model and are secured in place by the end piece as shown in the GIF below. I may update the model to support ½ inch drive, but may need to widen the base to fit the larger sockets.
Print Settings:
This holders can be printed in either PLA or PETG. No supports are needed.
- Material: PLA/PETG
- Layer height: 0.2mm
- Perimeters/Wall Loops: 2
- Sparse Infill Density: 20%
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (31)