Search models, users, collections, and posts
Aerobridge Garmin Mount for Clip On Aerobars
IP Report
Print Profile(2)
0.2mm layer, 3 walls, 30% infill
Designer
18 min
1 plate
0.2mm layer, 3 walls, 30% infill
18 min
1 plate
Open in Bambu Studio
Boost
28
101
4
1
192
90
Released
Description
Description
I signed up for a triathlon and purchased clip-on aero bars. (profile design). After installing these bars, I was not left with much space to mount my Garmin Edge 530 bike computer. So I designed an aerobridge that allows me to mount the Garmin quite easily.
Features
Snap in aerobars quickly. Take on and off easily. Standard diameter allows to mount any accessory as if it was getting installed on the handlebar directly
Printing
Quick and easy print, hollowed out for less material. No supports, Infill does not matter
Update
In addition to the basic model, I designed a model with springs built in which creates positive pressure to hold it in place firmly. Also added nubs on the underside to hold the Garmin rubberbands in place
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (4)