Door Card Clip
Print Profile(1)
Description
This clip was modelled for a Mercedes Sprinter rear door card/trim clip (green ones) that i lost. I think this is used on lots of other car makes and models.
Its probably better to buy the original clips as they aren't expensive but if you just need one in a hurry these work well and only take a few minutes to print.
I've printed in PETG to survive the heat in the vehicle but other high temp filament will also work. Printed with support which is a little fiddly to remove but sadly required.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (76)