Reel CooL Drink Holder Fishing Pole Drop Line

***PLEASE CLEAN YOUR BED PROPERLY BEFORE PRINTING. DAWN DISH SOAP(Or Equivalent) AND HOT WATER THEN DRY WITH PAPER TOWEL OR AIR DRY!! NOTHING ELSE NEEDED!! THIS WILL ENSURE YOUR PRINT IS SUCCESSFUL***

##  These models printed as shown but if you dont clean your bed properly and have adhesion issues, then you can add a brim or mouse ears. I test all my prints and it is proven to print as I set it up. ##

***Update after someone had issues with the print. I did some testing it appears my file got ruined during the Bambu Studio 2.0 Migration. I think i have it fixed mostly now the issue was with the support on the reel. It should print pretty well now but you may need to use your cutters to remove the support it is a bit stubborn unless you cut at it. I had to add extra support to help keep it in place.  PLEASE LET ME KNOW IF YOU FND ANY OTHER ISSUES***

REEL COOL The Drink Holder and Fishing Pole/Drop line Combination. (Built from Scratch with TinkerCad)

Also great for flying kites

I fine tuned this model to print with selected supports and orientations for cleanest and easiest printing results.

HIGHLY RECOMENDED TO PRINT THE “BOLT” ALONE WITH NO SUPPORTS AS IT PRINTS BEST WITH A SMOOTH EVEN FLOW

EVERYTHING HAS 999 WALLS

Arachne walls .20 Layers, top and bottom surfaces = monotonic line, Thick bridges enabled

Reel uses these supports > Normal(Auto) > Snug > Thresh A = 30 > BP Only = unchecked > Rem Sm= checked

**you should be able to grab a portion of the support with pliers and pull it out in large pieces if you grab in one of the larger slots it kind of unravels in its zig zag fashion

Cup and guide use these supports > Tree(Auto) > Tree Hybrid > Thresh a = 30 > BP Only = unchecked > Supp Crit = unchecked > Remove Sm= checked

Bolt needs no support

ASSEMBLY

**The line guide is designed to rotate 180 degrees to accomodate left or right handed fishermen

1. slide guide over post on cup with curved side towards can it should fit nicely either direction.

2. Slide Reel onto post with handle facing outwards

3. Thread screw gently in at first until it goes out in and out nicely, you can also use a nickle in the slot if you want to help as a screwdriver(use lube if neccesary, but it should run in smoothly if printed alone without supports) the tightness of the screw can be adjusted while fishing to help use as a brake when tighter and let the line out when loosened slightly

**Now you can attach your fishing line by feeding it through the eye hole guide on front side and then tying it around the reel and cranking it in with desired amount of fishing line