Search models, users, collections, and posts
Liner Dispenser
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
5.2 h
1 plate
Open in Bambu Studio
Boost
5
10
0
0
13
5
Released
Description
This design allows you to stack and store standar size daily liners for the ladies. It is convenient and good looking to have in the bathroom.
On the bottom of the model there's a slot where you can use a finger to slide out a single liner.
Liners are loaded from the top and stacked at 45deg angle.
The wall bracket is prepared to be installed with screws, however it can also be installed with double sided tape.
I have added support blockers to prevent unnessary supports, and allowed them just in the wide opening where the liners come out. It can be printed without them, however be prepared for a bit of a sag in that area.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)