Cartoon small dog Shiba Inu sitting | Cartoon small dog Shiba Inu

This is a small Shiba Inu sitting/standing posture model that I made in my free time. The idea is to create a small Shiba Inu that looks very happy. Seeing a little dog in this pressure-filled day will help relax your tense mood a little.

Later on, I thought about if I could make it stand up, which might be fun. So I modified the design, successfully made it stand up, and also added a doghouse. However, the support surface of the foot part is too small. It requires a bit of patience to make it stand up successfully, but sitting down might be easier, haha.

I adjusted the design and added grooves at the back of the ankles and the bottom of the base to install small magnets, increasing stability when glued together. I tested the effect myself and it worked well. The magnet sizes I used are: 194.52.5mm (rectangular) and 2.5~3mm in diameter, approximately 2mm in thickness (circular).

The hanging surface of the lower face on the side profile should be reduced, as there is some accumulation. I am not sure whether changing parameters or manually adjusting the model can fix it, but the effect should be improved.

I have also uploaded a model of a small dog in a four corner standing posture. You can take a look at it. Thank you for your understanding and liking it! ^_^
-----------
This is a sitting/standing posture model of a small Shiba Inu that I made in my spare time. The idea is to create a small Shiba Inu that looks very happy. Seeing a little dog in this pressure-filled day will help relax your tense mood a little.

Later on, I thought about if I could make it stand up, which might be fun. So I modified the design, successfully made it stand up, and also added a doghouse. However, the support surface of the foot part is too small. It requires a bit of patience to make it stand up successfully, but sitting down might be easier, haha.

I adjusted the design and added grooves at the back of the ankles and the bottom of the base to install small magnets, increasing stability when glued together. I tested the effect myself and it worked well. The magnet sizes I used are: 194.52.5mm (rectangular) and 2.5~3mm in diameter, approximately 2mm in thickness (circular).

The hanging surface of the lower face on the side profile should be reduced, as there is some accumulation. I am not sure whether changing parameters or manually adjusting the model can fix it, but the effect should be improved.

I have also uploaded a model of a small dog in a four corner standing posture. You can take a look at it. Thank you for your understanding and liking it! ^_^