Bambu A1 Adjustable Camera Holder
Print Profile(8)
Description
(A1 MINI VERSION IN MY OTHER MODELS)
During this upgrade, some parts of your printer may be damaged, I am not responsible for any damage caused by incorrect installation or other damage. If your cables appears too short for this mod you should not install it.
Another version of camera relocator, this time you can adjust the angle of the camera!
INSTRUCTION:
Print all 3 models as they are in print profile, camera holder should be printed with supports
DURING NEXT OPERATIONS THE PRINTER SHOULD BE TURNED OFF!
Remove original faceplace and camera according to BambuLab instruction
Push camera into it's new holder, it's supposed to be pretty tight so vibrations won't make any noise
Put new faceplate on the X-axis with the cable going through a hole and carefully bend the connector 90 degrees, it'll be easier to connect it.
Push the cable through camera holder hole and connect it.
Push in the camera facing down and rotate it so it locks
Put the back cover and adjust the angle
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (2095)