HueForge July4TH

Project: 4th-Fireworks.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:
PLA BambuLab Basic Blue Transmission Distance: 4
PLA BambuLab Basic Red Transmission Distance: 4
PLA BambuLab Basic Gray Transmission Distance: 2
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
Start with Blue
At layer #8 (0.72mm) swap to Red
At layer #13 (1.12mm) swap to Gray
At layer #20 (1.68mm) swap to Jade White for the rest.

HueForge was used to create the model and Bing's AI Designer was used to create the image.

If you resize the object, use only the X and Y axis as the Depth of the project will determine where the color changes occur.