U.S. Army M1A2 Abrams MBT - Kit Card
Print Profile(1)
Description
Membership
Printed at .08 layer height with an initial layer height of .16mm. Due to the angles on the hull, this was the best way of reducing the the layer ridges
Be careful when removing from the bed as you'll rip the side supports if you're too eager.
Use snips to cut the supports, and an exacto knife to trim.
Place the gun in it's position by forcing it upwards into the turret as you hold the block at the back of the gun, it will go in, but its a tight fit.
If you like this print, please support me with a boost, it's much appreciated.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (45)