Search models, users, collections, and posts
A1 PTFE Swivel Inlet Connector (No need to buy pneumatic connector)
Remixed by
IP Report
GIF
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
24 min
1 plate
Open in Bambu Studio
Boost
83
214
28
16
281
146
Released
Description
Content has been automatically translated.
Suitable for the A1 side inlet connector reserved hole
The connector design is 360 degrees rotatable, no need to buy pneumatic connector, can directly connect the filament tube
Attached with filament tube clip, hope you can use it
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (28)