Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
10.3 h
2 plates
Open in Bambu Studio
Boost
95
267
18
13
126
65
Released
Description
This is a Print-in-place Bird Feeder. I have designed this to be printed in ASA for UV resistance and to be able to print this in Ludacris Mode on the Bambu. Please be aware that you will need to pre-heat your bead before printing in ASA. This project is about 200g in total material. the bird feeder has a smaller bowl in the feeder so that birds have a place to perch inside as the feed drops.
Installation:
use some Twine or Paracord slip it thru the center of the feeder. tie a knot at the base to hold it up. If a knot is not sufficient you can use same of the Bambu ASA poop as a knot holder.
Other possable uses. The roof can be turned upside down and used as a mini Hanging bird bath.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (18)