Milwaukee Packout Hex Bit Insert 218 or 120 Bits
Print Profile(3)
Description
Membership
Models are for personal use only unless you join my $5 No-Limit Subscription. Sell physical prints of my models for as long you're subscribed!
Custom made drill bit insert for the small Milkwaukee Packout Shockwave Case!
Run both sides at the same time to hold 218 bits in one case! Nothing you can buy or print has this much capacity in such a small space. They are offset by ½ unit so no rubbing - my largest Phillips didn't hit my largest Torx. The square holes are 6.95mm x 6.95mm. I tested 6.9mm and 7.0mm before settling on this fitment. The bottom holds 120 bits the top holds 98 bits. Slice off one row or column if you need a test print.
218 Bits = Print top and bottom
120 Bits = Print bottom only
Form over Function: This may not be the best way to store 218 bits (sometimes inner bits can be hard to access) but it definitely is the cleanest looking way!
There's two versions of this case this is for the wider version. If you have the skinnier version message me lets figure out the sizing and I'll release it!
Boost Me (for free)
If you have any left, I would greatly appreciate you boosting my model. They go a long way!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (22)