Search models, users, collections, and posts
AirTag Keychain Holder
IP Report
Print Profile(8)
0.2mm layer, 2 walls, 15% infill
Designer
16 min
1 plate
0.08mm layer, 2 walls, 15% infill
26 min
1 plate
0.2mm Layer, 2 Walls, 15% Cross Hatch Infill
16 min
1 plate
Strong PETG 4 Pack - (0.2mm layer, 2 walls, 15% infill)
55 min
1 plate
Click to see more
Open in Bambu Studio
Boost
2339
7315
1087
449
13.9 k
12.4 k
Released
Description
Simple Apple AirTag holder for attaching to a keychain/keyring. Tolerances are fairly tight and the feel may change depending on filament/print settings, so some tuning may be required if not using given print profile.
There are some small markings on the side to assist in aligning the two halves. Once aligned, simply twist to close.
Thank you to @lj.salo for the cover photo!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (7)
Click to see more
Comment & Rating (1087)