Search models, users, collections, and posts
Kingdom Death Monster Plastic Board Adapter
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
14 min
1 plate
Open in Bambu Studio
Boost
6
21
3
2
18
8
Released
Description
This is a push fit adapter (very tight) for pieces on the Kingdom Death Monster Plastic Board. A few of the pieces need to be carved out to fit. This uses a 10mmx2mm round magnet. I am planning on using stickers to label the locations on the board. Added another print profile for a slightly smaller insert. Try both and hopefully one works better than the other. Also added a depth gauge insert block.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)